Idiomas disponibles
Idiomas disponibles
8
How to use the E-bike
Fully charge the battery before first use.
How to charge
a. Open the rubber cap and plug the charger into the e-bike charge port
Figure 11-1. Make sure that the charger port is in the given direction,
as shown in Figure 11-2.
b. Plug the charger into the mains wall socket.
c. When connected to the battery charger, the battery will start to charge
and the charge indicator on the charger will turn red.
d. After the charging is complete, the charge indicator will turn green.
Remove the battery charger when fully charged.
e. Close the rubber cap after charging.
Figure 11-1
How to start an E-bike
ON/OFF
Press and hold the power button ON/OFF for 3 seconds to turn on the
display.
PAS UP button
PAS DOWN button/
Press & hold 6 km/h push assistance button
Pedal Assist Level
The Motor offers five Bike Assists Models: ECO, NORMAL, TOUR, POWER,
BOOST. Short press Up or Down to switch the pedal assist level.
Figure 11-2
ON/OFF button
Mode button
Bluetooth
device
connected
Display Interface
By default the display shows real-time speed (km/h), the single mileage
(km), and the Total mileage (km). Press the MODE button briefly to switch.
Walk Assist
Pressing and holding the Down Button for 3 seconds activates Walk-Assist
Mode. The e-bike will go in a speed of up to 6 km/h automatically.
Settings Menu
Press and hold the Mode button for 2 seconds, and enter the Settings
interface.
How to set
Press the UP or Down to switch and press the Mode button to save.
Battery Indicator
Real Time speed
Toggle Riding Info
PAS level
