Würth 0715 53 110 Traducción De Las Instrucciones De Uso Originales página 15

Ocultar thumbs Ver también para 0715 53 110:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Battery exchange (fig. III)
If the battery symbol (15) is displayed, the supplied
voltage is too low for operation.
Exchange the battery as follows.
‰ Open the battery cover (5).
‰ Remove the battery (20) from the device and
exchange it with a new battery (item no. 0827
05).
‰ Close the battery cover (5).
Maintenance / cleaning
Note
DO NOT use any solvents for cleaning the lens.
The device may NOT be dipped in water.
Cleaning the lens:
‰ Remove loose parts using clean, compressed air.
‰ Remove remaining contamination carefully with
a soft brush.
‰ Wipe off the surface carefully with moist cotton
wool. The cotton wool can be moistened with
water.
Cleaning the housing:
‰ Clean the housing with soap solution and
sponge or a soft cloth.
Disclaimer
The information in these operating instructions can
be changed without prior notice. Würth does not
accept any liability for direct, indirect, accidentally
or other damages or consequential damages which
result from the usage or the application of the infor-
mation in these operating instructions.
Environmental protection
Do not dispose of the appliance
with domestic waste. Dispose of the
appliance only via an authorized
waste management company or
your municipal waste management
organisation. Adhere also to the
applicable regulations. In case of
doubt refer to your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner. Batteries may not be disposed of
with domestic waste. Hand in used batteries at your
supplier or at a battery collecting point.
Declaration of Conformity
We hereby declare that the appliance complies with
the relevant basic safety and health requirements of
the EU Directives, both in its basic design and con-
struction as well as in the version put into circulation
by us. This declaration shall cease to be valid if the
device is modified without our prior approval.
The device meets the following standards:
EN61326:1997 + A1:1998:+A2:2001+A3:2003
The product meets the requirements of the EMC
Directive 89/336/EEC
Technical documentation at:
Adolf Würth GmbH & Co. KG, Abt. PFW
74650 Künzelsau (Germany)
Chairman of
General Manager
Adolf Würth
GmbH & Co. KG
Künzelsau: 10.08.2010
15
loading