DELTA DORE Tycam Guard Manual De Instalación página 12

4 7 Impervious sheath for RJ 45 cable
If necessary, you can fit the sealing accessory for the RJ 45 cable.
1- Camera network
interface socket
①
2- Seal
3- Network plug
4- Seal plug
5- Rubber seal
6- Clamping nut
7- Network cable from the wireless router
Mounting
1. Pass the network cable (7) (without plug) through the
clamping nut (6),
the rubber seal (5) (inner edge of the rubber seal must
be opposite the seal plug), then through the seal plug
(4), in this order.
2. Crimp an RJ-45 network plug (3) onto the end of the
cable, taking care to insert the twisted pairs of wires
in the right order.
3. Place the seal (2) on the tip of the camera
network interface socket (1).
4. Insert the network plug (3) into the camera network
interface socket (1).
5. Insert the rubber seal (5) into the seal plug (4), then
screw the clamping nut (6) onto the seal plug (4)
without tightening it completely.
6. Align the seal plug snap-fit system (4) with the notch
on the camera network interface socket (1), then
screw the seal plug (4) a quarter turn on the camera
network interface socket (1).
7. Tighten nut 6, the sealed connection of the RJ45 plug is complete.
4 8 Connecting the power supply
- Connect the power supply.
22
② ③ ④ ⑤ ⑥ ⑦
① ② ③
①
②
④
⑤
⑥
4 9 Completing the installation
- Point the Wi-Fi antennae
upwards.
- Remove the protective film
from the camera.
5 - Connecting the camera
Select your connection mode :
WiFi
Connection modes by Wi-Fi link (2.4 Ghz).
⑥
The local Wi-Fi network must be secure.
⑦
Ethernet
Connection mode by Ethernet RJ45 link (Cat. 5E, max. 100m).
POE
The PoE connection mode is used to power the camera by the Ethernet RJ45 link. It requires a
Switch or PoE Injector to be installed as well as a category 6 Ethernet cable (not supplied).
Type and max. length according to the switch used (Poe SW4: 250m max).
PoE switch option: Poe SW4 Ref: 6417010
0°-270°
RJ45
RJ45
PoE switch
RJ45
RJ45
EN
23