Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Install fuel cap and let any spilled fuel evaporate before
starting engine.
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer, if adding a fuel preserver,fill the fuel tank with fresh
fuel. if only partially filled, air in the tank will promote fuel
deterioration during storage, if fuel preserver is not used,
drain the fuel tank, start the engine and let it run until the fuel
lines and carburetor are empty, Use fresh fuel next season.
See Storagefor additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreased performance, increased fuel consumption, and
increased emissions. See a qualified Sears dealer for high
altitude adjustment information. Operation of the engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
FreshStart@ Fuem Cap
The Fresh Start@fuel cap (A) is designed to hold a
cartridge (B) which contains fuel preserver. Adding fuel
preserver helps keep fuel fresh and carburetors clean for
easier starting all season long. The Fresh Start@fuel cap, f
equipped with a cartridge, automatically drips concentrated
fuel preserver into your fuel tank so you don't have to add it
yourself.
Lubricate OoRings
Lubrication of o-rings is extremely important for installation
and operation_The use of a lubricant (petroleum or synthetic
grease) during assembly helps seat o-rings properly and
provides an improved seal. it also helps protect the o-ring
from damage by abrasion, pinching or cutting and extends
the life of the o-ring_
NOTICE ALWAYSapply a small amount of lubricant on
o-rings prior to assembling the garden hoseto the pump (C),
high pressure hose (D), spray gun (E), and nozzle
extension (F).
Lubricateaii connections shown below, fallowing these
instructions:
1.
inspect and clean connecting surfaces prior to
lubrication and assembly.
2_ Use lubricants sparingly during assembly; a light film is
all that is required.
3.
Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
HOTICE Purchase a Fresh Start@fuel preserver cartridge,
Sears item 33386, at your local Sears or by calling 1-888-
331-4569 or online at www.sears.com, it is not included with
the pressure washer.
Read and follow all instructions and warnings given in the
Fresh Start@ fuel preserver cartridge package.
Tabla de contenido
