Switching ON and OFF
• The ON/OFF Switch (2) is located on the front of the spindle
sander (Image I)
• To turn the spindle sander ON: Press the green button marked
(-)
• To turn the spindle sander OFF: Press the red button marked (O)
Sanding
WARNING: Do not sand metal with this sander. Sanding metal
will cause sparks that may ignite wood and dust particles on the
sander or in the workshop.
Note: The spindle rotates in an anti-clockwise direction.
1. Check the machine is mounted securely on the workbench and
the Spindle Lock Nut (6) is fastened correctly with appropriate
Sanding Sleeve (11) and Table Insert (10).
2. Wear appropriate safety equipment, including face mask and
safety glasses, then switch on the dust extraction system (if
available)
3. Turn the sander ON and allow the motor to reach full speed
IMPORTANT: Feed the workpiece gradually, AGAINST the direction
of rotation, onto the Sanding Sleeve. Failure to do this could force
the workpiece away from the Sanding Sleeve with risk of injury. Do
not force the workpiece or apply excessive force.
4. When finished, turn OFF the machine and disconnect from
mains power
Accessories
• A range of accessories and consumables, including TSS80G,
TSS150G, TSS240G Sanding Sleeves (11) are available
from your Triton stockist. Spare parts can be obtained from
toolsparesonline.com
Maintenance
WARNING: Ensure the tool is switched off and the plug is
removed from the power point before making any adjustments or
carrying out maintenance.
• Any damage to this tool should be repaired and carefully
inspected before use, by a qualified repair technician
• Have your power tool serviced by a qualified repair technician
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained
General Inspection
• Regularly check that all the fixing screws are tight. They may
vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage
or wear. Repairs should be carried out by an authorised Triton
service centre. This advice also applies to extension cords used
with this tool
Cleaning
• Remove dust and dirt regularly. Frequently blow or vacuum dust
away from all sander parts and the Motor Housing (3)
• Periodically remove the Table Insert (10) and Lower Spindle
Washer (7) from the Spindle (5) and remove any dust
accumulation in the Table Insert area
• Re-lubricate all moving parts at regular intervals
• Never use caustic agents to clean plastic parts. If dry cleaning
is not sufficient, a mild detergent on a damp cloth is
recommended
• Water must never come into contact with the tool
Contact
For technical or repair service advice, please contact the
helpline on (+44) 1935 382 222
Web: www.tritontools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the reach
of children. If the tool is permanently setup in a workshop or
garage, ensure access is restricted to prevent children operating
the tool.
Disposal
Always adhere to national regulations when disposing of power
tools that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on
the correct way to dispose of power tools
EN
9