Idiomas disponibles
Idiomas disponibles
˜ Cleaning and maintenance
m
WARNING! Risk of injury!
Always switch the product off,
disconnect it from the mains and
let it cool down before performing
inspection, maintenance or cleaning
works .
m
WARNING! Risk of injury!
u
Risk of injury from moving dangerous
parts!
m
CAUTION!
u
Any maintenance and repair other than
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product . Only use original parts .
NOTE
u
The following cleaning and servicing
should be done regularly . This will ensure
a long and reliable service life .
˜ Cleaning
m
WARNING! Risk of electric shock!
u
Do not spray the product with water and
do not immerse it in water .
m
WARNING! Risk of injury!
u
Be careful with the line cutter
cutter can cause serious lacerations .
NOTE
u
Do not use cleaning agents or solvents .
You may otherwise irreparably damage
the product .
Keep clean the ventilation slots, motor
o
housing and handles of the product . Use a
damp cloth or a brush .
36 GB/IE
After every trimming session, remove grass
o
and soil from the protective cover
the trimming assembly .
˜ Maintenance
o
Prior to every use, check the product for
obvious defects such as loose, worn or
damaged parts .
o
Check covers and safety devices for
damages and correct installation . Replace
as necessary .
˜ Replacing the line spool
(Fig. D)
NOTE
u
u
u
1 . Unplug the mains plug .
2 . Open the spool cap
pressing both releases
3 . Remove the cover of the spool cap
take out the line spool
21 ]
[
. The line
4 . Press the line ends of the new spool out of
the slots
5 . Insert the new line spool into the spool
cap
winding direction of the spool is indicated
by arrows must be visible after insertion .
6 . Insert both ends of the line through the
opposite line outlet loops
The correct winding direction of the line
20 ]
[
spool
is specified in the spool cap
and on the line spool itself .
[
21 ]
Check the line cutter
product without a line cutter or with a
defective line cutter . If the line cutter is
damaged, contact our customer service .
Standard strings available from DIY stores
can also be used, allowing you to re-use
empty line spools (see "Technical data") .
The winding direction is indicated on the
20 ]
[
line spool
.
[
10 ]
19 ]
[
[
20 ]
[
23 ]
.
[
10 ]
. The side of the spool on which the
[
9 ]
and
10 ]
[
. Never use the
by simultaneously
on the spool cap .
10 ]
[
and
.
22 ]
[
.
