Idiomas disponibles
Idiomas disponibles
Instructions
Preparation before use
Filling with water: Open the water mixing valve, lift the mixing valve handle, turn it clockwise to the
1.
highest point of the high-temperature zone, then open the water inlet valve. The water is then sent to the
inner tank until the hot water outlet is normal. At this time, it indicates that the inner tank has been filled
with water, close the water mixing valve and turn the handle counterclockwise to the lowest point of the
low-temperature zone.
When the water temperature reaches the programmed temperature, the heating indicator on the panel
2.
turns green and the water heater automatically stops heating. The water temperature has reached the set
temperature and enters the heat conservation state. At this time, the user can activate the mixing valve
switch and slowly switch from the low-temperature zone to the heat conservation state. Turn the mixer tap
handle in the high-temperature area, carefully test the water temperature with your hands, adjust it to the
water temperature you need, then you can use it with confidence. When the water temperature falls to a
certain level, the water heater automatically warms up.
Note: the water temperature may be slightly higher, please test the water temperature before use, do not
test the water temperature on the human body, in order to avoid burns!
Closed
Open
Low temperature
High temperature
