Kidde Excellence KE-IO3101-M Hoja De Instalación

Excellence Series Intelligent Addressable High
Voltage Relay Module Installation Sheet
EN DE ES FR IT NL PL PT SV
1
EN: Installation Sheet
Figures
Figure 1: Device overview
(1) Mounting holes (×4)
(2) Loop terminal block
(3) Device status LED
(4) Test (T) button
Figure 2: Module installation (DIN rail)
Description
This installation sheet includes information on the
KE-IO3101-M Intelligent Addressable High Voltage Relay
Module (device type 1Onmi).
The module is loop powered and provides two unsupervised
outputs (synchronized) with normally open (NO), normally
closed (NC), and common (C) contacts. The module includes
an integrated short circuit isolator and is suitable for indoor
installation.
All 3000 Series modules support the Kidde Excellence protocol
and are compatible for use with 2X-A Series fire alarm control
panels with firmware version 5.0 or later.
© 2023 Carrier. All rights reserved.
(5) Output terminal block
(6) DIP switch
(7) Output status LED
2
Installation
WARNING: Electrocution hazard. To avoid personal injury or
death from electrocution, remove all sources of power and
allow stored energy to discharge before installing or removing
equipment.
Caution: For general guidelines on system planning, design,
installation, commissioning, use and maintenance, refer to the
EN 54-14 standard and local regulations.
Installing the module
Always use the NeXT System Builder application to calculate
the maximum number of modules that can be installed.
The module must be installed inside a compatible EN 62368-1
compliant protective housing (not supplied) − we recommend
the N-IO-MBX-1 DIN Rail Module Box. Remember to earth the
protective housing.
Note: An alternative protective housing may be used providing
it meets the specifications indicated in "Protective housing" on
page 3.
Mount the protective housing onto the wall using a suitable
mounting system for the wall characteristics.
Install the module onto the DIN rail inside the protective
housing as follows:
1. Hook the module onto the top of the DIN rail.
2. Push the module down to secure it onto the rail.
1 / 28 P/N 12-0201-501-4004-01 • ISS 21NOV23