Idiomas disponibles
Idiomas disponibles
OPERATION
Active functions*
Meat probe connected
Lighting on
OpenUp! - Automatic door opening
OpenUp! - Automatic door opening
Quick pre-heat
ECO active
Kitchen Timer active
Delayed timed operation
Timed operation
Child Lock Active
Oven pre-heat active
Pre-set programme active
Catalytic cleaning active
(unavailable)
Door lock and pyrolytic clean-
ing active (oven with pyrolytic
cleaning)
* depending on model
Connect the power supply
When you connect the power supply (or power
is restored after a power outage) the appliance
will prompt to set the current time,
flash on the display. You must set the current
time to use the appliance.
Note: In the event of a power outage, all
settings such as Duration, Temperature and
Heating Function will be lost. You will need to
re-enter the settings to continue cooking. If the
pyrolytic cleaning is interrupted (or the door
is locked for any other reason), the oven will
start the cooling and door opening procedure
before you can set the time.
Set the current time
When you connect the appliance to the
power supply, the hour
play. Use
Touch
once to switch to the minutes digits
and then use
time. Touch
time. You will hear a beep when the current
time is stored in the appliance. To change the
current time in the Standby mode, touch and
hold
. The
display. Touch the
the digits will start to flash. Now you can pro-
ceed to set the current time.
The display brightness.
The LED display brightness varies depend-
ing on the time of day. The display is dimmed
during 22:00 to 06:00 and its brightness is
normal during 06:00 to 22:00. Also, the dis-
play is brighter when active than when the
appliance is in Standby mode. The display
brightness and display dimming times cannot
be changed.
Lighting
The lighting turns on each time you open the
oven door. The lighting also turns on when
the oven is in active mode. This lighting is off
in Standby mode. If the oven door remains
open for a long time, the lighting will automat-
ically turn off after about 10 minutes.
will
flash on the dis-
and
to set the current time.
and
to set the current
again to confirm the current
symbol will be show on the
sensor once again and
45
