Shop-Vac 87MT Serie Manual Del Usuario página 7

ASSEMBLY (CONT'D)
c. Tilt the tank forward slightly and locate the hole provided in the underside of the
dolly directly below the slot containing the square nut.
d. Place the screw, containing the flat washer, into the hole and turn clockwise until end of screw is
connected to square nut. If you have difficulty getting the screw to connect to the square nut, push
downward on the square nut with the eraser end
of a pencil while turning the screw.
e. Finish tightening the screw using 7/16" socket, wrench or nut driver.
f. Repeat steps a to e with the second slot in dolly.
g. Turn tank upside down so bottom is facing up. Continue on to step 4 below.
4. Place one hair pin clip in one end of axle. Slide one washer down the length of the
axle to rest on the hair pin clip. Slide wheel onto axle next to washer. Be sure flat side
of wheel hub is facing outward.
5. Slide axle through holes provided in tool rack.
6. Slide remaining wheel then washer onto axle. Insert hair pin clip into remaining hole
in axle to hold wheel in place.
7. Install tool rack assembly onto dolly (already installed on tank) by placing large slot in
tool rack over rim on back of dolly. Push tool rack onto dolly until the bottom of tool
rack is flush with bottom of dolly.
NOTE: It is normal for tool rack to fit tightly onto dolly.
8. Secure with four screws provided.
9. If plastic flat washers are included in hardware pack, place one flat washer over stem of each caster.
NOTE: Flat washers are not required with all units.
10. Insert casters into front of dolly by placing stem of casters into holes provided. Apply
pressure and twisting motion until casters snap into place.
11. Return tank to upright position.
PAGE 6