Idiomas disponibles
Idiomas disponibles
OPERATION - General information
The below description goes with image 1 on page 2.
1. Telescopic tube
2. Hose
3. Hose connector
4. Hose grip
5. Mechanic suction pressure control at the handle
6. Combi nozzle
7. Motor unit
8. Cover
9. Cover release button (dust bag)
10. Vacuum-cleaner handle
OPERATION - Before use for the first time
Verify that a dust bag is fitted. Fit a dust bag, if necessary. See 'Changing the dust bag'.
OPERATION (see figure 2, 3, and 4)
1. Rotate the hose connector into the hose opening on the motor unit to the right (see Figure 2a). To
remove the hose, rotate the connector to the left and pull the connector from the hose opening.
2. The power cord has a yellow and red mark, see Figure 2b. Pull out the cord to the yellow mark.
3. Put the plug in the wall socket, and press the On/Off switch. To switch off the appliance, press the On/
Off switch again, see Figure 2c.
4. The appliance is now ready for use. You can move the vacuum cleaner while you are cleaning by
pulling on the hose grip. You can lift the appliance with the vacuum cleaner's handle, see Figure 2d.
5. You can adjust the vacuum suction with the vacuum suction control, see Figure 2. It is advisable to
reduce the vacuum suction when cleaning upholstered furniture and curtains. This will prevent the
fabric from being sucked into the nozzle.
6. Slide the telescopic tube onto the hose handle, see Figure 3a.
7. Press the button on the telescopic tube and keep it pressed in; you can then extend or retract the tube
to the required length. See Figure 3b.
8. Press the foot button on the nozzle to set the combi nozzle for use on hard or soft surfaces, see Figure
3c. For use on hard surfaces, press the foot button on the combi nozzle to extend the brushes. Lift the
button for use on soft surfaces.
ATTENTION:
•
Never pull out the power cord beyond the red mark. This could damage the power cord.
TIPS:
•
If so required, you can also reduce the suction quickly by moving the slide on the hose grip.
•
This vacuum cleaner is supplied with a crevice tool with a narrow nozzle, which you can use to clean
radiators, window frames, crevices, small openings, and similar (see Figure 4).
OPERATION - Storage after use (see figure 5 and 6)
1. Remove the plug from the wall socket.
2. Press the rewind button and keep it pressed in; the power cord will automatically rewind onto the reel.
3. Stand the vacuum cleaner upright. An attachment slot for the accessory bracket is fitted to the back
of the vacuum cleaner next to the front castor (see Figure 6). Slide the bottom of the accessory
bracketinto the slot. This avoids the need to dismantle the vacuum cleaner after use; you can store the
assembled appliance and retrieve it again quickly when you need it.
ATTENTION:
•
Guide the power cord whilst it rewinds onto the reel, since otherwise the cord could become tangled or
the plug could strike the back of the appliance. Take hold of the power cord near the mark, and allow it
to gently slide through your fingers back into the appliance, see Figure 5.
11. Rear wheels
12. Swivelling front wheel
13. Cord-rewind button
14. On/Off switch
15. Indicator, "dust bag full"
16. Crevice tool
17. Exhaust filter
18. Storage bracket
19. Electronic suction pressure control
17
17
EN
EN
