Craftsman 580.327750 Manual Del Operador página 12

Idiomas disponibles

Idiomas disponibles

0030" FEELER GAUGE
(O,,76mm)
Figure-9
CLEAN SPARK ARRESTOR
SCREEN
WARNING: LETTHE MUFFLERCOOLBEFORE
WORKINGON IT+CONTACT WITH A HOT MUF-
FLEROR ENGINECANCAUSESEVEREBURNS+
The engine exhaust muffler has a spark arrestor screen+
Inspect and clean the screen every 25 hours of operation
or once each year, whichever' comes first.
NOTE: If you use your' generator on any forest-covered,
brush-covered or grass-covered unimproved land, it must
have a spark anestor.. The spark arrestor must be main-
tained in good condition by the ownedoperator+
Clean and inspect the spark arrestor as follows:
To remove the heat shield from the muffler (Figure-3),
remove the three bolts that connect the shield to the
muffler.
°
Remove the phillips head screw that attaches the
spark arrestor screen.
Pull screen straight ouL
°
Inspect screen and replace if torn, perforated or oth-
erwise damaged+ DO NOT USE a defective screen. If
the screen is not damaged, clean it with a commercial
solvent.
°
Reattach the screen and the heat shield.
SERVICE RECOMMENDATIONS
Fill in DatesAsYouComplete Regular
HOURLY OPERATING I NTERVAL
Service
SERVICE DATES
Before
Every 25
Every 50
Every 100
MAINTENANCE
TASK
EachUse
Hours or
Hours or
Hours or
Yearly
Yearly
Yearly
ENGINE
X
Check011 Level
................................
,
............
:
.............
i, .........
L
L
....
Change Engine Oil*
X**
Service Air+ Cleaner
X***
C{eard Replace SparkPlug
X
Prepare ForStorage
Prepare unitfor storage if _tisto remain idle for MORE
THAN30 DAYS
"Change
oil after first 2 hours of operation,
then after every 2 hours,
** Change sooner when operating under heavy Goador high ambient
temperature
"*'Clean more often under dirty or dusty conditions
ENGINE SPEED
Your generator engine runs at a constant speed+ This
constant operating speed is maintained by a mechanical,
flyweight type, fixed speed governor+ DO NOT try to
adjust the governed speed setting for' the following rea-
sons:
High engine speeds are dangerous and increase the
risk of personal injury or damage to equipment+
°
Low engine speeds impose a heavy load on the
engine when sufficient engine power' is not available
and may shorten engine f_fe+
The generator will supply correct rated AC frequency
and voltage only at the proper speed+ Some con-
t2
loading