Idiomas disponibles
Idiomas disponibles
2.4 Deactivating a radio re-
mote control
If a radio remote control unit is to be taken
out of service from one
instantaneous water
heater, the following steps should be taken to
ensure safety in use.
The registration procedure on one of the
remaining remote controls must be repeat-
ed 6 times as described in section 2.3.2
- 'First start up'. By so doing the specific
registration of the individual sender code
of the removed control will be over written.
If more than one radio remote control unit
remains, each of them must be re-registered
again as shown in 2.3.2
2.5 Deactivation of the
acoustic receiving signal
If the customer wishes to deactivate the
acoustic signal, the receiving module should
be opened and connector (13) pulled out.
If the signal later needs to be reactivated, it is
merely necessary to plug in the connector once
again.
2.6 Handover
Explain the functions of the unit to the user.
Make him or her aware of the safety instruc tions,
in particular. Hand over the operating and
installations instructions to the user.
For notes on
"Environment, recycling, customer
service and guarantee" see operating and
installation instructions for DHE electronic
comfort.
9
