Idiomas disponibles
Idiomas disponibles
EN
4.6 - Factory parameters reset
To return all the parameters to their default values or to change the type of equipment on which the control panel is installed, proceed
as follows:
1. Press and hold the button
2. Scroll through the menu items with the buttons
3. Press and hold the button
of motor in use.
4. Select with the buttons
The display shows a countdown from 50 to 0; release the button when the text
5. The control unit exits the MENU after seven seconds of inactivity or by briefly pressing the
!
WARNING
If the type of motor is changed, all the values are returned to the factory value and it is necessary to perform a new
auto-learning procedure for the travel.
5 - SYSTEM CUSTOMISATION
The configuration menus of the equipment operating functions are divided into BASE and ADV (basic/advanced). The following tables
show the description of each basic parameter with the respective minimum, maximum and default values.
1. Press and hold the button
access the basic menu.
2. Scroll through the menu items with the buttons
3. Press and hold the button
4. To change the value, use the buttons
(MENU) until the display stops flashing
5. To exit the menu, briefly press the button
NOTE: to view the value of any parameter simply enter the relevant menu (BASE or ADV) using steps 1 and 2 of the procedure just
described. Once the desired parameter has been identified, the display alternately shows the name of the parameter and the value.
To exit the menu, briefly press the button
5.1 - Basic parameters
PARAMETERS
1
2
3
4
5
6
7
14
(MENU); the display shows in sequence
(UP) and
(MENU); release the button when the display starts flashing; the number displayed indicates the type
(UP) and
(DOWN-RADIO) the type of motor; press and hold the button
(MENU); the display shows in sequence
(UP) and
(MENU) until the display flashes; release the button
(UP) and
(DOWN-RADIO) ; to confirm the new value press and hold the button
(MENU)
(MENU)
DESCRIPTION
Automatic re-closing time (0 = off)
Re-closing time after the transit on PH1 (0 = off)
Obstacle sensitivity
0 = maximum impact force
10 = minimum impact force
Door speed in opening
1 = minimum speed
5 = maximum speed
Door speed during the slowing down phase in opening
1 = minimum speed
5 = maximum speed
Door speed in closing
1 = minimum speed
5 = maximum speed
Door speed during the slowing down phase in closing
1 = minimum speed
5 = maximum speed
; release the button near the text ADV.
(DOWN-RADIO) until reaching
appears.
and
, release the button at the wording
(DOWN-RADIO) until reaching the desired parameter
(MENU)
DEFAULT
(MENU).
(MENU) button.
MIN
MAX
0
0
900
0
0
30
3
0
10
4
1
5
1
1
5
4
1
5
1
1
5
to
UNIT
s
s
