CD2610
Troubleshooting
Problem
Cause
Does not operate
No power to yellow wire; no
(display does not light)
power to red wire
Inline fuse blown
No power to unit
Inline fuse blown
No speakers operate
Speaker harness not
(display lights normally)
connected
Not all speakers
Incorrect splices or
operate
connections
Speaker wires shorting to
chassis ground or to each
other
Blows fuses
Power wire shorting to
ground
Speaker wires shorting to
ground
Incorrect fuse/fuse too small Install fuse of correct rating.
CD skips too much
Receiver mount is not solid
or backstrap is not secure
Corrective Action
Check connection with test light;
check vehicle fuse with test light.
Replace fuse.
Check/replace fuse.
Connect speaker harness; check
speaker wires.
Check all splices and connections.
Check splices, insulate all bare
wires.
Make sure wire is not pinched.
Make sure wire is not pinched.
Check mounting and backstrap,
tighten if needed.
Specifications
CEA Power Ratings
Power Output . . . . . . . . . . . . . . . .13 watts RMS X 4 channels into 4-ohms @ < 1% THD+N
Signal to Noise Ratio . . . . . . . . . . . . . 70dBA below reference. (Reference: 1 watt, 4-ohms)
Frequency Response . . . . . 20Hz to 20kHz (-3dB), Auxiliary input used as source reference
Reference Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14.4VDC
CD Player
Signal-to-noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >86dB
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz-20kHz, -3dB
Channel separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >55dB @ 1kHz
D/A converter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Bit/CH
FM Tuner
Tuning range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5MHz-107.9MHz
Mono sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12dBf
50dB quieting sensitivity (stereo) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16dBf
Stereo separation @ 1kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >35dB
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30Hz-12kHz. +3dB
AM Tuner
Tuning range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 530kHz-1710kHz
Sensitivity @ 20dB signal to noise . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30uV
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30Hz-2kHz., -3dB
Auxiliary Input
Input sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . .400mV RMS for 1 watt RMS into 4-ohms
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz to 20kHz, -3dB
Input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 k-ohms
General
Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-16 VDC, negative ground
Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 amp fast blow ATO
DIN chassis dimensions . . . . . . . . . . . . . . . . . . . . . . . 7"x 7"x 2"(178mm x 178mm x 51mm)
Specifications subject to change without notice.
23
