PLAYKIN MOTO KID Manual Del Usuario página 43

STEP 2
Installing the Foot mount.
Take out the Foot mount,
align the Foot mount with
the slot on the bottom of the
motorcycle body, and fix it with
four screws.
STEP 8
Installing the Handlebar. Take out the handlebar, use a screwdriver to
remove the screw shaft on the handlebar, and then put the handlebar into
the round tube of the front fork, align with the slot, and then use the screw
shaft to pass through the slot under the handlebars and the iron tube in
order. Finally use a screwdriver to fix it until the handlebar does not shake.
butt joint
STEP 6
Installing the Front of the Motorcycle. Take
out the front of the motorcycle, first connect the
wire connection terminals of the front and the
main motorcycle body. Then align the hooks on
the front of the car with the slots on the front of
the motorcycle body and insert it directly to the
bottom. Finally, fix it with two screws under the
front of the car. Caution: Make sure to connect the
headlight wire before installing the front.
STEP 7
Installing the Front Wheels. As shown in
the figure, first put the fender on the front
wheel fork, then use the front wheel shaft to
hold the front wheel on the front fork, and
finally use the nuts to fix it.
Caution: When fixing the front wheel, put
two shaft sleeves inside the front fork, and
the gaskets and nuts are placed on the
outside of the fork in order.tube in order.
43
ASSEMBLY
EN