PLAYKIN MOTO KID Manual Del Usuario página 42

STEP 4
Installing the License. Plate Take
out the license plate, plug it into the
slot at the rear of the motorcycle,
and fix it with screws.
STEP 3
Installing the rear wheel. First take
out the motor, connect the motor wire
to the connect wire in the motorcycle
body, and snap the motor into the
motor slot. Then install the rear wheel
which has the plum blossom and snap
it into the motor gear. Then insert the
rear axle through the rear wheel, the
motor, and the motorcycle body. Next,
on the other side of the rear axle, insert
a pipe plug and a sleeve and the other
rear wheel in order. And finally use the
gaskets and nuts to fix the both sides.
Caution: Make sure to connect the
motor wire when installing the motor.
Rear wheel assembly diagram
STEP 5
Installing the Seat. Insert the seat into the two slots
of the motorcycle body, press down, and then rotate
the movable lock at the rear of the seat and align it
with "close". Caution: Please plug in the positive and
negative wires of the battery before installing the seat.
butt joint
STEP 1
Installing the Foot Pedals. Take out the foot pedals,
insert the foot pedals into the grooves on both sides of
the motorcycle body until the "click" is heard then the
installation is completed.
Caution: When installing the foot pedal with foot switch,
connect the foot switch cable first.
42
butt joint