Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
Please ensure that you check the following before contacting the service organization:
Symptom
Machine refuses to start
Fluctuating pressure
Machine stops
Fuse blows
Machine pulsating
Machine often starts and stops by itself
Machine starts, but no water comes out
In case problems other than the above occur, please contact your local distributor.
28
Cause
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cable
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Fuse too small
Air in inlet hose/pump
Inadequate supply of mains water
Nozzle partially blocked
Water filter blocked
Hose kinked
Spray handle is leaking
Pump/hose or accessory frozen
No water supply
Water filter blocked
Nozzle blocked
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
Recommended actio
Plug in machine.
Try another socket.
Replace fuse, switch off other machines.
Try without the extension cable.
Check that hoses and connections are airtight.
Clean and replace or refer to local distributor.
Clean and replace or refer to local distributor.
Replace fuse.Switch off other machines.
Check that the mains voltage
corresponds to specification on the model tag.
Leave the washer for 5 minutes to cool down.
Clean the nozzle.
Change to an installation higher than
the amp. Consumption of the machine. You may
try without the extension cable.
Allow machine to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
specifications required.
Clean the nozzle.
Clean the filter.
Straighten out hose.
Contact your nearest service centre.
Replace seat/ball/o-ring in the valve
of the spray handle.
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
Clean the filter.
Clean the nozzle.
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
