Do not over tighten the mounting screws. Damage to the printed circuit board will result.
Reconnect the power leads to the replacement board two position connector by inserting the
stripped ends of the wire into the connector as far as they can travel. Make sure supply lead
insulation is flush with connector. If stranded wire is used, be sure that there are no loose
strands outside the connector plug that could touch the adjacent lead and cause a short circuit.
Observe polarity when making connections. Place the outer dome back into position,
reinstall the two outer dome screws and apply power to verify proper operation.
F. Service.
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied
by a Return Material Authorization. This R.M.A. can be obtained from the local Distributor
or Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction,
should be provided.
Address all communications and shipments to:
G. Replacement Parts.
Description
Strobe Tube
P.C. Board Assy., 12V
P.C. Board Assy., 24V
Dome, Fresnel, Amber
Dome, Fresnel, Blue
Dome, Fresnel, Red
Dome, Fresnel, Green
CAUTION
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
Part Number
K149128A
K2001201A
K2001201A-01
K8263079A
K8263079A-01
K8263079A-02
K8263079A-03
3
