Sears Kenmore 526.51672100 Guía Para El Uso Y Cuidado página 13

Refrigerador duplex
Idiomas disponibles

Idiomas disponibles

CAUTION
To avoid property damage, observe tile following:
• Do not force ice maker arm down or up.
• Do not place or store anything in ice storage bin.
WARNING
To avoid possible injury, including death, do not place glass
items in ice cream shelf, Glass objects may shatter or
explode if exposed to extreme cold.
Primary
Features
Automatic
Dispensing
ice
Maker
This ice maker creates the ice used in the dispensing
system.
Using Ice Maker for the First Time
Confirm ice bin is in place
and ice maker arm is down.
After freezer section reaches
between 0° to 2°F (-18 ° to
-17 ° C), ice maker fills with
water and begins operating.
Allow approximately
24 hours after installation to
receive first harvest of ice.
Discard ice created within first !2 hours of operation to
verify system is flushed of impurities.
Operating
Instructions
Confirm ice bin is in place and ice maker arm is down.
After freezer section reaches 0° to 2°F (-18 ° to -17 ° C),
ice maker fills with water and
begins operating. You will have a
_ ......
complete harvest of ice
approximately every 3 hours.
Stop ice production by raising ice
maker arm until click is heard.
Ice maker will remain in the off position until arm is
pushed down.
Drawers
8asker
To remove and install basket:
• To remove, lift front of basket
and pull out to its full
extension
Lift up front of
basket and remove.
• To install, slide basket into rails at bottom of freezer
section, Lift up front of basket, and slide to the back of
unit.
Freezer
Features
ice
Cream
Shelf
Ice cream shelf provides a space for items to be
chilled or frozen quickly.
• To remove, lift ice cream shelf
from ice bin rails and pull
straight out.
• To install fit shelf over top of
ice maker and lower onto ice
bucket rails.
ice
Storage
Bin
The ice storage bin is located below the automatic
dispensing
ice maker.
T0 remove and install ice storage bin:
I
To remove bin, remove ice cream shelf.
Raise ice maker arm to deactivate
ice
_
maker. Lift front of bin and pull out
to its full extension. Lift up front of
_'_
bin and remove,
• To install, slide bin into rails below ice maker until bin
locks into place. Drop ice maker arm to activate ice
maker, and replace ice cream shelf.
IMPORTANT:
Ice bin must be
locked in proper place for proper
_
_._.
ice dispensing.
If freezer door
[_/_
_o
does not close, bin is not in proper
location. Turn auger driver counterclockwise
(as shown)
to properly align ice bin with back of unit.
Ill
Z
Z
Shelves
Freezer
Shelf
To remove and install clip-mounted
shelves:
To remove
pull shelf from wall
mounting clips and pull left side
of shelf out of wall mounting
holes
To install, place shelf in mounting hole and attach to
wall mounting clips,
wall mounting clips, Be sure back edge of shelf is
flush with back of cabinet and snap shelf into cabinet
railing.
Door
Storage
Door
Buckets
1
13
loading