Idiomas disponibles
Idiomas disponibles
NOMINAL
DIAMETER
OF WOOD
SCREW (mm)
3.1
3.5
3.8
4.5
4.8
5.1
5.5
5.8
8.0
CAUTION
• Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only damage the tip of your
bit,decrease the tool performance and shorten the service life of the tool.
• There is a tremendous force exerted on the tool/bit when drilling the hole. Hold the tool firmly and be careful when the bit begins to
break through the workpiece. A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back
out. However, the tool may back out abruptly/ if you do not hold it rmly. Always secure small workpieces in a vise or similar
hold-down device.
CHARGING
DRILLING OPERATION
Place the point of the driver bit in the screw head and apply pressure to the
RECOMMENDED
tool.
SIZE OF
Start the tool slowly and then increase the speed gradually. When you
PILOT HOLE (mm)
tighten the screw, you have di culty in turning the screw, then release the
switch
2.0 - 2.2
trigger.
First, turn the adjusting ring, so that the pointer points to the drilling marking.
2.2 - 2.5
Then proceed as follows.
2.5 - 2.8
DRILLING IN WOOD
2.9 - 3.2
When drilling in wood,the best results can be achieved with wood drills
3.1 - 3.4
equipped with a guide screw. The guide screw makes drilling easier by pulling
the bit into the workpiece.
3.3 - 3.6
DRILLING IN METAL
3.5 - 3.9
To prevent the bit from slipping when stating a hole,make an indentation
3.8 - 4.1
with a center-punch and hammer at the point to be drilled. Place the point of
the bit in the indentation and start drilling. Use a cutting lubricant when
5.0 - 5.5
drilling metals
Befor using the driver drill,charge the battery as follows.
1. Insert the battery pack into the mains adaptor of the charger.
2. When the charger is plugged into the wall outlet, the red charging light is
illuminated and it will remain lit during charging.
3. When the charging light changes from red to green, charging completes.
4. After charging, unplug the charger from the power source
1. Indicator light
2. Battery polarity
3. Charger polarity
8
YEAR
1
WARRANTY
