Idiomas disponibles
Idiomas disponibles
ADJUSTING THE FASTENING TORQUE
OPERATION
The fastening torque can be adjusted in 19 steps by turning the
adjusting ring so that its graduations are aligned with the poiner on the
tool body. The fastening torque is minimum when the number 1 is
aligned with the pointer.And as the number get bigger, torque will
become stronger as well, and it is maximum when the drill marking is
aligned with the pointer. Before actual operation, drive a trial screw into
your material or a piece of duplicate material to determine which torque
level is required for a particular application.
NOTE :
• Do not operate the tool with the adjusting ring set between the
number 18 and the marking. The tool may be damaged.
1. Graduations
2. Adjusting ring
3. Drill marking
4. Pointer
SCREWDRIVING OPERATION DRILLING OPERATION
Place the point of the driver bit in the screw head and apply pressure to
the tool.
Start the tool slowly and then increase the speed gradually. When you
tighten the screw, you have di culty in turning the screw, then release
the switch trigger.
CAUTION
• Make sure that the driver bit is inserted straight in the screw head,
otherwise, the screw and/or bit may be damaged.
NOTE :
• When driving wood screws, predrill pilot holes to make drilling easier
and to
avoid splitting of the workpiece. See the chart.
7
YEAR
1
WARRANTY
