Festool A-225EN Manual De Instrucciones página 5

Chuck BF-FX
The chuck is used to clamp drills and bits.
Fitting:
- Place the chuck on the drill spindle (2.5) and
twist until the hexagon key (2.4) of the chuck
latches into the hexagon socket of the drill
spindle.
- Pull the unlocking ring (2.3) forwards, press the
chuck onto the drill spindle up to the stop and
release the unlocking ring.
Removal:
- Pull the unlocking ring forwards and remove
the chuck.
Changing tools:
- Turn the clamping sleeve (2.2) anti-clockwise
to open the clamping jaws (2.1)
(Note: the spindle is automatically locked when
the machine is switched off).
- Insert the tool into the chuck.
- Clamp the tool by turning the clamping sleeve
clockwise. Always make sure that the tool is
clamped centrally in the chuck.
Angle attachment DD-AS
The angle attachment permits work (drilling,
screwing) vertical to the machine's longitudinal
axis.
Fitting:
- Place the angle attachment on the drill spindle
and turn until it catches in the desired position
(Note: The angle attachment can be fi tted in
16 different angle settings).
- Lock the angle attachment by turning the fas-
tening ring (2.7) tightly clockwise.
Removal:
- Turn the fastening ring anti-clockwise up to the
stop and remove the angel attachment.
Fitting / removal of chuck on angle attach ment:
The chuck is fi tted on the shaft (2.6) of the angle
attachment in the same way as on the drill spindle
of the machine.
Eccentric attachment DD-ES
The eccentric attachment is used to hold bits. It
allows screwing close to edges.
Fitting / removing the eccentric attach ment:
The eccentric attachment is fi tted / removed in
the same was as the angle attachment (see DD-
AS).
Changing tools:
Pull the unlocking ring (2.8) back and remove the
tool and/or insert the new tool.
CENTROTEC WH-CE toolholder
The CENTROTEC toolholder enables rapid changes
of tools with CENTROTEC shafts.
Danger of injury! When changing
tools, handle the tool and its sharp cutters with
special care and wear protective gloves, if neces-
sary.
Do not fi t CENTROTEC tools at the
round shaft section in a conventional chuck to
prevent damage to the shaft.
Fitting
- Pull the release ring (2.11) forwards, place the
toolholder as far as it will go on the drill spindle
(2.5) and let go of the release ring.
Removal
- Pull the release ring forwards and take off the
toolholder.
Changing tools
- To insert or remove a tool with CENTROTEC
shaft, pull the green release ring (2.10) back.
On inserting the tool, turn it until its hex shank
arbour (2.9) locks in place in the hexagonal
shank of the drill spindle, and push the tool into
the toolholder as far as it will go.
Tool holding fi xture in the drill
Bits can be fi tted directly in the hexagon socket
holder of the drill spindle (2.5) to make the ma-
chine lighter and shorter.
Charge battery pack
To load the battery pack, push it into the holder
(3.1) on the charger up to the stop. Perform this
in reverse to remove the battery pack from the
charger.
The battery type used (NiCd or NiMH) is detected
automatically. Charging is controlled by a micro-
processor.
If a warm NiMH battery pack (>37° C) is insert-
ed, charging will only be carried out at a lower
charge current. In this case, the charging time is
extended.
5
spindle