Idiomas disponibles
Idiomas disponibles
Front chin strap
Front
To tighten the rear strap, pull excess from the rear of strap 2. Hold the helmet with one hand. With the other hand,
hold the strap where they pass under your chin. Then pull from side to side to balance the length of all four straps
(See Diagram B).
The helmet must sit firmly and level on your head. (See Diagram C) To lower the front of the helmet to cover your
forehead, tighten the chin strap and loosen the rear strap. To raise the front, loosen the chin strap and tighten the
rear strap.
To check fo proper tension,put on the helmet and fasten the buckle. Open your mouth. You should feel the strap
pulling against your chin.
Then attempt to pull the helmet off the front or rear. If the helmet comes off, increase strap tension and examine if
thick enough pads are being used. The helmet should not be able to roll forward or backward excessively. It should
not be possible to remove the helmet without unfastening the buckle.
NOTE: Please check adjustment every time this helmet is worn.
Final check
The important thing to remember is that the helmet fits snugly. If you can fit it forward or backward, you need to
tighten the strap adjustment.
The straps should be positioned that they do not cover the ears and that the buckle is away from the jaw when
correctly fitted.
Buyer should always try different sizes and choose the size which feel secure and comfortable on the head.
It is important for the helmet to fit snugly on your head and must be fastened to provide maximum protection.
All adjustments should be checked each time the helmet is worn, making sure it fits snugly at all time.
Caring for your helmet
Clean the headgear with mild soap and water only. The use of any solvents, paints or decals can cause damage to the
helmet and make it ineffective in the result of an accident.
Keep helmet out of extreme Heat
Helmet will be damaged if exposed to temperatures exceeding 150°F. Dark vehicles and storage bags can exceed this
on very hot days, Heat damaged helmets will have random disfigured areas where the texture appears bubbly and
uneven. If damaged, helmets should be destroyed and replaced immediately.
Important information
This headgear is designed to absorb the energy of a blow by partial destruction or damage itself. Even though such
damage may not be visible, the helmet should be destroyed or replaced, if it is involved in an injury-related fall.
Unfortunately some accidents result in head injury that cannot be prevented by any helmet. Depending on the type
of impact, even very low speeds can result in a serious head injury or fatality. Always ride with extreme caution and be
sure to read this manual thoroughly.
Pull up to balance
strap lengths
Rear strap
Diagram B
Correct
5
Incorrect
Diagram C
