Idiomas disponibles
Idiomas disponibles
110/220v
DUaL-vol t
Keep Working
S i
6 1 6 0
M D v
Once the value to work has been selected, just press the knob to exit to the main mode.
TIG MODE SETTING
TIG mode is factory set for highest output, so pressing the knob in TIG mode will not give you the option to any additional
menus or settings.
Operation environment
• Height above sea level ≤1000 M
• Operation temperature range -10〜+40°C
• Air relative humidity is below 90 %(20°C)
• Preferable site the machine some angles above the floor level, the maximum angle does not exceed 15 .
• Protect the machine against heavy rain AND against direct sunshine.
• The content of dust, acid, corrosive gas in the surrounding air or substance cannot exceed normal standard.
• Take care that there is sufficient ventilation during welding. There must be at least 30cm free distance between the machine
and wall.
Operation Notices
• Read Section §1 carefully before starting to use this equipment.
• Connect the ground wire with the machine directly.
• Ensure that the input is single-phase: 50/60Hz, 110V ±10%.
• Before operation, none concerned people should not be around the working area and especially children. Do not watch the
arc in unprotected eyes.
• Ensure good ventilation of the machine to improve Duty Cycle.
• Turn off the engine when the operation finished for energy consumption efficiency.
• When power switch shuts off protectively because of failure. Don't restart it until problem is resolved. Otherwise, the range
of problem will be extended.
• In case of problems, contact your local dealer if no authorized maintenance staff is available!
KEEP WORKiNG
KEEP WORKiNG
Keep Working
MMA
110/220v
DUaL-vol t
TIG
Keep Working
S i
6 1 6 0
M D v
21
S i
6 1 6 0
m D v
MMA
TIG
