Qilive Q.6341 Manual De Instrucciones página 25

8. TROUBLESHOOTING TIPS
Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
Problem
Dishwasher doesn't
start
Water not pumped from
dishwasher
Foam in the tub
Stained tub interior
White film on inside
surface
Possible Causes
Fuse blown, or the
circuit breaker tripped.
Power supply is not
turned on.
Door of dishwasher not
properly closed.
Kink in drain hose.
Filter clogged.
Kitchen sink clogged.
Improper detergent
Spilled rinse aid.
Detergent with
colourant may have
been used.
Hard water minerals.
25
Solution
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Make sure to close the door property and
latch it.
Check drain hose.
Check the coarse filter.
(see section titled „ Internal Care „)
Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen
sink that is not draining , you may need
a plumber rather than a serviceman for
dishwashers.
Use only the special dishwasher detergent
to avoid suds. If this occurred, open the
dishwasher and let suds evaporate.
Add 1 gallon of cold water to the tub.
Close and latch the dishwasher, then Start
any wash cycle to drain out the
water. Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure that the detergent has no
colourant.
To clean the interior, use the damp soft
cloth with dishwasher detergent and
wear rubber gloves. Never use any other
cleaner than dishwasher detergent for the
risk of foaming or suds.
EN