Garant 434336 Manual De Instrucciones página 23

2. Install HCT app.
» HCT app is installed.
8.4. TRANSFERRING MEASUREMENT VALUES USING THE HCT APP
ü Hoffmann Group Connected Tools has been downloaded on to a smartphone or tablet.
ü Bluetooth has been activated on the smartphone and dial indicator.
ü BT has been activated in APP an Messuhr mode.
1. Select the dial indicator from the list of devices in the HCT-App.
2. Transfer the data by pressing
» The measurement values are now saved in the HCT-App and can be exported as a CSV file.
9. Maintenance
Interval
According to individual requirements
9.1. CHANGING THE BATTERY
1. Pry open the battery compartment carefully with a slot-head screwdriver.
2. Replace CR2032 battery (positive terminal pointing upwards).
3. Insert battery compartment and press into casing.
10. Cleaning
Remove dirt using a soft, clean and dry cloth. After contact with liquids, dry mechanical parts well. Do not use chemical, al-
cohol-based, abrasive or solvent-based cleaners.
11. Faults table
Fault
Nothing displayed.
Data shown on the display is difficult to
read.
No connection to the HCT APP
ERR0
ERR1
ERR2
ERR3
ERP4
ERR8
ERR9
ERR.BT0
ERR.BT1
ERR.BT2
DATA
or request the transfer directly using the HCT-App.
Maintenance work
Recalibration according to C1 Cal
Possible cause
Battery is flat.
Low battery.
Bluetooth has been deactivated.
Overspeed, incorrect sensor distance or
alignment.
Sensor is faulty.
Parity error
Unknown command
Sensor measuring range exceeded.
RS buffer full
Failed flash drive access.
Failed flash drive access.
BT connection parameters outside the
recommended values.
Undefined error.
BT initialisation failed.
Performed by
Hoffmann Group customer service
Action
Insert fully charged batteries of the
same type.
Activate Bluetooth on the measuring
tool and end device.
SET button to clear the error.
Contact Hoffmann Group customer ser-
vice.
Check the connection parameters.
Command not supported.
SET button to clear the error.
Change the communication speed or re-
duce the number of commands.
SET button to clear the error.
Switch device OFF and ON.
Contact Hoffmann Group customer ser-
vice.
Contact Hoffmann Group customer ser-
vice.
Change the BT connection parameters
or connection interval.
Switch device OFF and ON.
Check the battery.
Switch device OFF and ON.
Contact Hoffmann Group customer ser-
vice.
www.hoffmann-group.com
de
en
bg
da
fi
fr
it
hr
lt
nl
no
pl
pt
ro
ru
sv
sk
sl
es
cs
hu
23