LG WM3570H A Serie Manual Del Propietário página 16

10 INSTALLATION INSTRUCTIONS
Leveling fhe washing machine
The washer tub of your new washing machine spins
at very high speeds. To minimize vibration, noise, and
unwanted movement, the floor must be perfectly level
and solid.
Check the washing machine's level.
- Check the precise level by rocking the top edges
of the washing machine or placing a level on the
washing machine. The slope beneath the washing
machine must not exceed 1o, and all four leveling
feet must rest firmly on the floor.
Level
Turn the lower leveling feet clockwise to level the
washing machine.
- Turning the lower leveling feet clockwise raises the
washing machine.
Raise
3 Turn the Iocknuts counterclockwise and tighten them
when the washing machine is level.
Tighten all 4 lock
nuts securely using
the wrench.
4 Checkthe washing machine's level again.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does
not rock.
- If the washing machine rocks, repeat steps 1 to 3.
A WARNING
o Using the washing machine without leveling,
it may result in malfunction caused by the
production of excess vibration and noise.
o If you are installing the washing machine on the
optional pedestal, you must adjust the leveling
feet on the pedestal to level the washing machine.
The washing machine's leveling feet should be
minimized and turn the Iocknuts counterclockwise
to secure.
o Use the leveling feet only when you level the
washing machine. If you raise the leveling feet
unnecessarily, it may cause abnormal vibration of
the washing machine.
2
3
If you install the washing machine on a slippery
surface, it may move because of excessive vibration.
Incorrect leveling may cause malfunction through noise
and vibration. In the event of this, lay the non-skid pads
under the leveling feet and adjust the level.
1
Clean the floor to attach the non-skid pads.
- Use a dry rag to remove and clean foreign objects
or moisture. If moisture remains, the non-skid pads
may slip.
Adjust the level after placing the washing machine
in the installation area.
Place the adhesive side of the non-skid pad on the
floor.
- It is most effective to install the non-skid pads
under the front legs. If it is hard to place the pads
under the front legs, place them under the back
legs.
S This side up __ X
Adhesiv
Rernove
backing
4 Checkthe washing machine's level again.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does
not rock. If the washing machine rocks, level the
washing machine again.