Kinderkraft NESTE UP2 Guia Del Usuario página 23

• Information on the types of adult bed for which the bedside sleeper is
suitable can be found on picture K.
• User shall not use other attachment system.
• Bedside sleepers shall never be used in an inclined position
• To prevent a suffocation hazard from entrapment, the bedside sleeper
shall be properly secured to the adult bed using the attachment system.
• There shall never be a gap between the lower side of the bedside sleeper
and the mattress of the adult bed.
• Check the tightness of the attachment system before each use by pulling
the bedside sleeper in a direction away from adult bed.
• If there is any gap between the bedside sleeper and the adult bed, DO NOT
use product.
• Gaps should not be filled with pillows, blankets or other items.
• DANGER! – Always completely raise the drop side when not attached to
the adult's bed
• WARNING! To avoid hazards from the child's neck being caught on the
top rail on the side that is next to the adult bed, the top rail must not be
higher than the adult bed mattress.
• WARNING! To avoid the risk of your child being strangled the
attachment system to the adult's bed shall always be kept away from
and out of the crib.
1. List of baby cot components - page 4
1 Frame of the cot with cover
2 Middle support of the cot's bottom
3 Side bracket in the cot padding
2. Mounting of the cot:
Prepare a suitable surface so as not to damage the product during assembly. Lay the cot frame with cover (1) on a flat
surface. Holding the cot frame, lift the legs until they are apart (fig A). Then remove the plastic caps/secures on the
legs and slide the castors into the legs (fig. B). Correct assembly is characterised by a click. Turn over and place the
unfolded main frame with the sheathing (1) on a flat surface. Then connect the central support (2) to the legs of the
cot by sliding it into the corresponding holes on both sides (fig. C) and fasten it with hook-and-loop closures (fig. D).
Slide the lower support (3) into the legs (fig. E). The assembled product is shown in fig. F.3.
3. Height adjustment:
The cot is adjustable to 5 different heights. To adjust the desired height hold the cot with your foot, move button A
sideways while pressing button B and adjust the frame of the cot to the desired height (fig. F).
4. Bedside cot:
To connect the cot to the parents' bed, remove the safety devices at the locks (fig. G). Unlock the zips on both sides (fig.
H). Slide the lever and slide out the tube of the side panel (fig. I). Repeat on the other side. Remove the side panel of
the cot (fig. J) and pull the tube out of it. Adjust the height of the cot to the parents' bed (fig. K). Fasten the buckle of
4 Mattress
5 Fastening straps
6 Wheels x2
23