11.10. SETTING THE PROTECTED PARAMETER "COOLING SETPOINT"
This parameter allows you to set the minimum temperature below which disable any accessory for the management of water coil
(if the plenum accessories PLS or PLSM no provision for such an accessory, this parameter will not be considered);
To set the cooling setpoint it is necessary to enter in the password protected menu (as shown in paragraph 11.7), using the naviga-
tion keys to run through the operating parameters until the parameter SPC is displayed. Press the MODE/SELECT key to enter the
parameter modification mode and use the navigation keys to select the desired value (the accepted range of values is from 8°C
to 33°C, default value is 20°C). Then press the MODE/SELECT key to confirm the selection and exit from the parameter modifica-
tion mode.
Note: The battery water post-treatment summer, if present, is automatically activated in manual mode, AUX or AUTO as needed.
Season parameter (SPC):
1
2
The appearance of the SET icon shows that the system is
awaiting modification of the parameter (default cooling set-
point value 20°C)
3
Once the value is confirmed the name of the parameter
is again displayed.
WARNING: Once in the password protected menu press-
ing the navigation keys (
the various parameters. If during the display of the SEA
parameter the (
menu and to return to the password menu it is necessary
to repeat the procedure detailed in paragraph 11.7.
36
4238010_02 - 1302
,
) permits moving between
) key is pressed this exits the password
1
Activate parameter modi-
fication mode
2
Set the desired cooling
setpoint
3
Confirm the selected
value