Idiomas disponibles
Idiomas disponibles
Keep third parties away from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit, thus
decreasing the risk of accidents.
To avoid all dangers associated with welding process,
always wear personal protective clothing and equipment.
Wearing an approved hand-held welding mask with
suitable protective lenses or approved side-shield goggles,
long-sleeved clothing, safety shoes, gloves and leather
apron, mask and ear plugs under the appropriate
conditions reduces the risk of injury.
While welding, always pay attention to the heating plate.
While operating the power tool, you should bear in mind
that:
▪ Do not operate this power tool in damp or wet conditions;
▪ Before each use, you should check the insulation of the
power cord, cables and attached accessories in order to
avoid electric shocks;
▪ Fumes and welding gases can harm you permanently. To
avoid these hazards, the workplace must be well
ventilated to keep fumes and gases away from the
breathing area;
▪ Toxic fumes and gases may be released when handling
synthetic materials, paints, varnishes and similar
materials;
▪ Do not touch the heating plate without unplugging the
power cord and letting the appliance cool down. Always
wear gloves;
▪ Let the power tool cool down completely before storing.
Before
performing
cleaning,
changing, repairing and maintenance work, the power cord
must be unplugged from the socket.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool must be cleaned thoroughly after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official distributor.
If any components or safety devices are removed for
maintenance
works,
immediately and correctly.
Use only VITO-approved attachments for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the pipe welding machine.
If in doubt, if you lack knowledge or resources, you should
contact an official distributor.
Your pipe welding machine should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
adjusting,
accessories
they
must
be
repositioned
