Idiomas disponibles
Idiomas disponibles
W
Watts
min
minutes
Alternating
Current
Position of date code
The Date Code, which also includes the year of manufacture, is
printed into the housing.
Example:
2023 XX JN
Year of manufacturing
Additional safety instructions for batteries
and chargers
Batteries
Š Never attempt to open for any reason.
Š Do not expose the battery to water.
Š Do not store in locations where the temperature may
exceed 40 °C.
Š Charge only at ambient temperatures between 10 °C
and 40 °C.
Š Charge only using the charger provided with the tool.
Š When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Chargers
Š Use your Stanley charger only to charge the battery in
the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Š Never attempt to charge non‑rechargeable batteries.
Š Have defective cords replaced immediately.
Š Do not expose the charger to water.
Š Do not open the charger.
Š Do not probe the charger.
#
Electrical safety
This charger is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
Š If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service Centre in
order to avoid a hazard.
Features
1. Perimeter handle system
2. On/Off slide switch
3. Foam pad base
4. Speed dial
5. Battery
6. Battery release button
Earthing Terminal
Safety Alert
Symbol
/min.
Revolutions or
Reciprocation per
minute
(Original instructions)
@
ASSEMBLY AND ADJUSTMENTS
Warning! To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Attaching Woolen Wax Applicator Bonnet
@
(Fig. A, B, D)
WARNING: If any parts are missing, DO NOT
operate this buffer/polisher until the missing
parts are replaced. Failure to do so could result in
possible serious personal injury.
1. Attach the wax applicator bonnet ( 8 ) to the foam pad
base ( 3 ) as shown in Fig. A. ALWAYS make sure the
elastic strip on the bottom of the bonnet is securely tucked
on the underside of the foam pad.
2. For paste wax, use a putty knife or any other flat object,
apply paste wax to the bonnet by spreading a teaspoon
of wax evenly over the entire surface of the wax
applicator bonnet as shown in Fig. B.
IMPORTANT: Do not apply wax directly on vehicle.
3. For liquid wax, apply three swirls of wax over applicator
bonnet. This should be enough to cover 1/4 of vehicle
surface as shown in Fig. D.
4. For the second, third, and fourth applications, only use
about one half as much as on first application. The bonnet
will not absorb as much wax on these applications.
Attaching Terry Cloth Polishing Bonnet
(Fig. C, D)
1. Place the terry bonnet ( 9 ) on foam pad ( 3 ).
2. ALWAYS make sure that the elastic strip on the bottom
of the bonnet is securely tucked on the underside of the
foam pad.
3. Apply wax in a circular motion as shown in Fig. D.
@
OPERATION
Warning! To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Installing and Removing the Battery Pack from
the tool
To install battery pack (Fig. E)
Š Insert battery pack ( 5 ) firmly into tool until an audible
click is heard as shown in figure E. Ensure battery pack is
fully seated and fully latched into position.
ENGLISH
19
