Idiomas disponibles
Idiomas disponibles
1) In case of error message on the display (e.g. E51- only tumble dryer with the display):
Switch the tumble dryer off and on. Set programme. Push the Start/Pause button. Does not
work? - inform local service and quote the error code.
2) follow programme recommendation - see PROGRAMMES chapter
3) see CARE AND CLEANINGchapter
4) see section MACHINE SETTINGS in HINTS AND TIPS chapter
5) only dryers with the display
6) Only dryers with drum light.
7) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
DRUM LIGHT
Only use a special bulb which is de-
signed specially for tumble dryers. The
special bulb can be obtained from your
local service centre.
WARNING!
When the appliance is switched
on, the interior lighting switches
itself off after 4 minutes when
the door is open.
WARNING!
Do not use standard bulbs!
These develop too much heat
and may damage the appliance!
Before you replace the bulb,
disconnect the mains plug; with
a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this
can be found directly behind the
loading aperture, at the top; refer to
"PRODUCT DESCRIPTION" chap-
ter.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring
gasket before screwing back the door
light cover. Do not operate the tumble
dryer when missing o-ring gasket on
door light cover.
WARNING!
For safety causes , the cover
must be screwed down tightly. If
this is not done, the tumble dry-
er must not be operated.
SERVICE
If there are technical faults, first check if
you can remedy the problem yourself
with the help of the operating instruc-
tions - see section TROUBLE SHOOTER
If you cannot remedy the problem on
your own, get in touch with the Cus-
tomer Care Department or one of our
service partners.
To assist you quickly, these data are
necessary:
– Model name
– Product number (PNC)
– Serial number (Ser. No. is on rating
plate attached to the product - to find it
see chapter PRODUCT DESCRIPTION))
– Type of failure
– Any error messages shown by the dis-
play.
So that you have the necessary refer-
ence numbers from your appliance at
hand, we recommend that you write
them in here:
Mod.
.................................
PNC:
.................................
Ser. No.
.................................
ENGLISH
21
