Idiomas disponibles
Idiomas disponibles
20
TROUBLE SHOOTER AND SERVICE
TROUBLE SHOOTER
Problem
Tumble dry-
er does not
work.
Unsatisfac-
tory drying
results.
Door does
not close
Err (Error)
on the dis-
5)
play.
No drum
6)
light
Abnormally
elapsing
time on the
5)
display
Drying cycle
too short
Drying cycle
too long
1)
Possible cause
Tumble dryer not connected to
mains supply.
Loading door opened.
The Start/Pause button not
pressed.
Incorrect programme set.
The filter clogged.
Too high volume of the load.
Airflow slots covered up.
Dirt inside the drum.
High water hardness.
Filter not locked in position.
Laundry locked between the
door and the seal.
Attempt to change parameters
after start of the programme.
The function you set is not ap-
plicable with the set programme
Defective drum light.
Time to end is calculated on the
basis of: type, volume and
dampness of laundry.
Small laundry volume./Too dry
laundry for selected pro-
gramme.
The filter clogged.
Too high volume of the load.
7)
Laundry insufficiently spun.
Very high room temperature -
no appliance fault.
Remedy
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
Close loading door
Push the Start/Pause button.
Set applicable programme.
3)
Clean the filter.
Respect the maximum load vol-
ume.
Uncover airflow slots.
Clean the drum inside.
Set applicable water hardness
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Set requested parameters.
Turn the tumble dryer off and
on. Set requested parameters.
Contact the service centre to re-
place the drum light.
Automatic procedure; this is not
a appliance fault.
Select time programme or high-
er drying level (e.g. Extra Dry ).
Clean the filter.
Respect the maximum load vol-
ume.
Spin adequately the laundry.
Lower the room temperature if
possible.
2)
4)
.
