Idiomas disponibles
Idiomas disponibles
410-120
Raise the motor unit (A) with handle (E)
Stop the grinder by turning the switch to position "O"
and remove the dressing brick (O) from the vise
Setting the Depth Gauge
Put the chain in the vise jaws (14), with a cutter up
against the chain stop (10)
With the motor unit (A) pulled down, turn the cutter
adjustment knob (8) to move the chain so that the
cutter's depth gauge is below the grinding wheel (K)
Turn the adjustment knob (9) to position the chain
stop (10) laterally to the center of the cutter
With the motor unit (A) pulled down, adjust the
grinding depth on the gauge by turning knob (5)
Set the depth gauge following the instructions
given in the "Operating Instructions, Sharpening
the Chain" section on pages 26–27 For this type
of sharpening procedure, there is no difference
between the right and left cutters, therefore
sharpen all the gauges one after the other
Check if the gauge depth is correct, using the
template with the shape related to the type of
chain used Also consult the chain table on
page 12 , column D
Operating Instructions
29
