Idiomas disponibles
Idiomas disponibles
8. AUX SEND control knob
AUX[1-4]
For adjusting the level of the signals output to the SEND jack and AUX[1-4]
AFL (After-Fader Listen)
For each AUX BUS: use this switch to feed the corresponding AUX SEND signal into AFL BUS, so
this signal can be monitored at the PHONES jack.
9. POWER level control
The level meter LED shows the level of the signal in the MAIN and SUB[1-2/3-4] buses or selected
PFL channel.
The "0" segment corresponds to the nominal output level. The level meter PEAK indicator lights
when output reaches the clipping level.
10. SOURCE SELECT
Sets the signal sent to the MAIN OUT jack, PHONES jack, and level meter. You can use this switch
to select the signal from the MAIN BUSES, SUB 1-2 buses or SUB 3-4 BUSES.
MAIN BUSES: [MAIN] button push up.
SUB 1-2 BUSES: [SUB] button push down, [1-2] button push up.
SUB 3-4 BUSES: [SUB] button push down, [3-4] button push down.
11. SUB fader
-
(SUB 1-2) fader. For adjusting the level of the signals output to the (SUB OUT 1, 2) jacks.
-
(SUB 3-4) fader. For adjusting the level of the signals output to the (SUB OUT 3, 4) jacks.
-
(TO MAIN) switch. If it is on, the signals are sent to the MAIN BUS via the (SUB 1-2, 3-4) faders.
12. MAIN( L-R) master fader
For adjusting the level of the signals output to the MAIN OUT jack.
8
