Idiomas disponibles
Idiomas disponibles
Trouble
There is spark on
the HF igniting
board
Arc can not be
ignited (TIG)
There is not spark
on the HF igniting
board.
No gas ow (TIG)
Gas always ows
Reason
The welding cable is not
connected with the two output
of the welder
The welding cable damaged
The earth cable connected
unstably
The welding cable is too long
There is oil or dust on the
workpiece
The distance between tungsten
electrode and workpiece is too
long
The HF igniting board does not
work
The distance between the
discharger is too short
The malfunction of the welding
torch switch
Gas cylinder is close or gas
pressure is low
Something in the valve
Electromagnetic valve is
damaged
The gas-test on the front panel
is on
Something in the valve
Electromagnetic valve is
damaged
The adjustment knob of pre-gas
time on the front panel is
damaged
31
SWEISSWELD.COM
Solutions
Connect the welding
cable to the welder's
output
Repair or change it
Check the earth cable
Use an appropriate
welding cable
Check and remove it
Reduce the distance
(about 3mm)
Repair or change Pr8
Adjust this distance
(about 0.7mm)
Check the welding
torch switch, control
cable and aero socket
Open or change the
gas cylinder
Remove it
Change it
The gas-test on the
front panel is o
Remove it
Change it
Repair or change it
