Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE TAP
Install the tap with regard to use and aesthetics. When drilling
through the kitchen worktop or sink, before drilling, make sure
that the dimensions are suitable for installing the washers, nuts
and joints under the kitchen worktop or sink (Fig. 6). Otherwise,
there is a risk that you will carry out the drilling incorrectly.
The tube should be carefully installed between the tap and the
clean water outlet of the system.
Water connection ttings
CONNECTION OF THE WASTE WATER
To install the waste water outlet, drill into the 8 mm diameter hole of the clamp in the same tube
(Fig. 7 b). Connect one end of the 3/8-inch tap to this clamp and the other end to the 3/8-inch outlet.
a
Fig. 7: Waste water connection
1 Tap tube
2 Upper tap body
3 Tap handle (open/close)
4 Hub cover
5 Tap body
6 Housing sleeve
7 O-ring of the housing sleeve
8 Mounting piece
9 Plastic mounting piece
10 Plastic mounting washer
11 Washer
12 Compression nut
13 Thread bar
14 1/4" hose
b
6
Fig. 6: Tap
Fig. 8: Water inlet valve
