Idiomas disponibles
Idiomas disponibles
Please read the operating instructions and pay particular attention to the chapters about
installation, operation, maintenance and warranty conditions. The operating sequence
of the system is shown in Figure 4.
WARNING
1- Make sure that the installation is protected against possible freezing.
2- Do not intervene in the waste water system.
3- However, if muddy water (clay etc.) comes out of the pipe, close the water inlet valve of the system.
4- If you wish to use a water supply system other than the local water supply system, it must be
subjected to a drinking water analysis by the responsible institutions.
5- If the water used is not tap water, make sure that the water is properly disinfected.
The lters are considered accessories
and are not covered by the warranty.
Tap water
Clean water
Waste water
Fig.4: Installation of the
reverse osmosis system
WATER CONNECTION
Close the water inlet valve.
After the remaining water in the tubes has been
drained at the appropriate points, connect the
3-way adapter to the water inlet. Make sure that
there are no leaks. First, install the 1/4" ball valve on
the adapter by wrapping it with Te on tape in a
position that allows easy opening and closing of
the ball valve (Fig. 5 a). Then, connect the water
supply hose to the ball valve (Fig. 5 b). Make sure
that the ball valve is closed (Fig. 5 c). Open the
water inlet valve and check the installation for
possible leaks (Fig. 5 d). Place the system in a
suitable place under the sink in an upright position.
6
1
3
5
4
3
5
7
1- Reverse osmosis system
2
2- Water inlet valve
3- Water inlet
4- Waste water outlet
5- Clean water outlet
6- Waste water clamp
7- Tap
d
Fig. 5: Water connection
ttings
e
d
b
