Polisport GUPPY JUNIOR Manual Del Usuario página 13

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
11. The seat must always be used with the foot protection plates (D1) and
wheel protector (D3). Their use is mandatory, since they keep the child's foot
and hands from coming into contact with the wheel, thus preventing
accidents. Assemble the footrest (D2) by successively installing the metal
fixing plate (E1/E1.2), the fixing block (E2), the footrest (D2) 1x screw (E3), the
HOW TO SAFELY PLACE AND SECURE THE CHILD ON THE SEAT
12. Open the seat belt (B) by simultaneously pressing the 2 points of the lock
(B1) and opening the buckle.
To safely place the child on the seat you must place the bicycle on flat and
solid ground for maximum bicycle stability. Even if your bicycle offers robust
quick stands, you must always hold the bicycle, while placing/ removing the
child. You must carry your child in your lap and safely place him on the seat.
HOW TO REMOVE THE SEAT FROM THE BICYCLE
1. Detach the safety-belt (C) to remove the child seat. To remove the seat from the luggage carrier, lift the security ring (G2) and simultaneously unfasten the
hand knob (G1) to open the jaw (G3) wider than the width of the luggage carrier. Push the seat up and backwards.
Make sure you have followed and fulfilled all the instructions given. When
done so, the child bicycle seat is ready for use.
SPECIFIC INSTRUCTIONS FOR USE
• Remove the non-safety-related stickers from the child bicycle seat before use.
• The rider must be at least 16 years of age.
• Check for any laws and regulations that might be in force in your country,
relating to the carrying of children in seats attached to cycles.
• Only transport children who can sit independently for an extended period,
aligning with the planned bike trip duration, and who can responsibly
maintain their balance autonomously on the seat throughout the journey,
without adversely affecting the bike's equilibrium.
• Do not carry a child less than 6 years of age in this child bicycle seat. To be
a passenger, the child must be able to sit up straight with the head held
upright while wearing a bicycle helmet. A doctor should be consulted if the
child's growth is questionable.
• Make sure that the weight and height of the child do not exceed the
maximum capacity of the seat, and check this at regular intervals. Check the
weight of the child before using the child seat. Under no circumstances
should you use the child bicycle seat to transport a child whose weight is
above the permissible limit.
• Make sure to check from time to time that the weight and height of the
child do not exceed the maximum permissible load of the seat.
• Make sure that it is not possible for any part of the child's body or clothing
to come into contact with moving parts of the seat or bicycle and check this
as the child grows.
• You must cover any sharp or pointy objects on the bicycle (e.g frayed
cables) that may be reached by the child, in any situation.
• A wheel protector is mandatory to prevent the child from inserting its feet
or hands between the spokes. The use of protection underneath the saddle
or the use of a saddle with internal springs is mandatory. Make certain that
the child is not able to hinder the brakes, thus avoiding accidents. These
adjustments should be revised with child´s growth.
• Cover any exposed rear saddle springs.
WARNINGS
WARNING: Do not attach any additional luggage to
the child seat. If you carry extra luggage, the bicycle' s
carrying capacity must not be exceeded, and we
recommend that it be placed at the front of the bike.
foot protection plate (D1) and the last 1x screw (E3). Tighten (6 N.m) the 2
screws (E3) of the footrest using the supplied Allen Key (E4). Make sure that
the foot guards (D1) are placed horizontally and properly secured both on
the bike seat stays and on the carrier. The retractable footrest (D2) must be
folded up when not in use, as shown on the image.
It´s forbidden for the child to climb alone on the bicycle or using the
footrests to reach the seat.
13. When you have placed your child in the seat, fasten the belt around the
child's waist and click the buckle closed. Note: Before starting the journey,
always check that the child is secured and that the belt is snug but not so
tight that it hurts the child.
IT IS MANDATORY TO READ the following chapter on safety
instructions about using your child bicycle seat.
• When the child bicycle seat is not in use, fasten the waist buckle of the
security harness to prevent the straps from dangling and entering in contact
with some turning part of the bicycle as wheels, brakes, etc. as these may be
a hazard to the cyclist.
• Secure the child into child bicycle seat ensuring that all the safety belts and
straps applied firmly but not so tight as to cause discomfort to the child.
• Check the security of fastners frequently.
• You must ensure that you always use the restraint system, and that the child
is secured in the seat.
• Dress the child in proper clothes according to weather conditions.
• Children in child seats need to be more warmly dressed than riders of cycles
and should be protected from rain.
• Remove the seat when transporting the bicycle by car (outside the car). Air
turbulence might damage the seat or loosen its fastenings or other
suspended elements, which could lead to an accident.
• Accompanying persons should carefully consider stability / balance when
placing the child on the bike in the seat.
• Make sure that children wear a suitable helmet that complies with EN
1078:2012+A1:2012 while riding in the seat. Not wearing a helmet
exponentially increases the risk of death, long-term disability, head trauma,
or other injuries. As bicycle seat manufacturers, we care about the safety of
seat passengers, so we strongly recommend that children and all passengers
wear properly fitted and fastened bicycle helmets.
• The seat and cushion can get hot if under the sun for a long time. Make sure
that they are not too hot before seating the child.
• This child seat is not suitable for use during sporting activities, or in extreme
conditions as per example: enduro, hard mountain biking, big road holes,
jumps and off-road ways.
• When riding for the first time with the seat fitted - to test ride the cycle in a
safe/quiet environment before riding on the highway.
WARNING: Do not modify the seat.
WARNING: The cycle could behave differently with
a child in the seat particularly with regarding to
balance, steering and braking.
#polisportmove
13
loading