Idiomas disponibles
Idiomas disponibles
Use
the list below
to help
solve
minor
problems.
What!s
the problem?
What
to do
Cleaner
won't
run
Low suction
Water
puddling
behind
cleaner
Won't pick up dirty solution
Cleaner pushes a line of dry debris
in front of it
Cleaning solution won't dispense
Brushes
won't
rotate
¢" Make sure the cleaner is
plugged
in firmly.
¢" Check the fuse or breaker.
¢" Empty the recovery tank; it may be full
ant{ the automatic
shut-off engaged.
¢" Make sure filter and filter lid are properly
positioned.
¢" Make sure tanks are locked in place.
¢" Check the filter and clean if dirty.
¢" Make sure nozzle is replaced
properly
and locked.
¢" Use recommended
detergents
to reduce
excess foaming.
¢" Make sure solution tank is installed
properly.
¢" Empty recovery tank.
¢" Check Mode selector dial to ensure it is
set for WET PICKUP.
/ Make sure recovery tank is installed
properly.
¢" Empty recovery tank.
/ Make sure filter and filter lid are properly
positioned.
¢" Check Model selector dial to ensure it is
set for DRY VAC.
¢" Tip nozzle off floor by pushing
down on
h_indle to pick up debn's that 1_too large
to clear the squeegee.
¢" Make sure solution tank is locked in
position.
¢" Refill the solution tank if it is empty.
¢" Check Mode selector dial to ensure it is
set for WASH.
¢" Reset circuit breaker.
(1) Push ON/OFF
switch to turn cleaner
OFE
Wait
one minute.
Plug the cleaner into electrical outlet.
Pudh the ON/OFF
switch again to
turn cleaner ON.
If the brushes continue to stall and the
breaker trips again, clean the brushes to
remove debris.
Continued
-_
17
