BEFORE TURNING ON
- Piease remove the ribbon-cushion placed on the
ribbon and check the rating label on the bottom to see if the rated voltage corresponds to
the local voltage before plugging in the AC cord.
Ribbon cushion is located under printer cover.-
ACTIVATE BACKUP BATTERY
Before you start using the calculator, piease remove the insulation paper below the backup
battery.
1.
Turn the AC power switch OFF and remove the battery compartment cover
located on the bottom case.
2.
Remove the insulation paper located below the backup battery.
3.
PRESS THE RESET SWITCH.
4.
Replace the battery compartment cover.
5.
Turn ON the AC power switch.
6.
Program the date and time according to the instruction manual.
J11
^REPLACING THE RIBBON
/;'i
'
=
'
"v
Your calculator is shipped with a 2-color ribbon already in place. You do not need to install
nr change it before you begin using the calculator. When you have been using your
calculator for some time, however, the print will gradually become faint, indicating that you
should change the ribbon. To change the ribbon, follow these steps.
^jlS8 |
m
i.
Remove paper roll, tearing paper at rear of calculator. Use the Paper Advance (f)
jffc|
H Hf
key to feed the remaining paper tape through the printer. Then remove the printer
111 . \ : -
S-
cover.
-
: =:
2.
Remove the old ribbon by pulling upward.
i§§
3.
Install the ribbon spool with the black edge up. Roll from the outside of the full spool
1|T
.
"
and place the first spool on the spindle not engaged by the lever. Thread the new
3
ribbon along the outside of the guides and in front of the print wheels. Switch the
H
i
<Y
\Y~:"
lever to the other side and replace the second spool.
I
^T-- - 4.
Rotate the spools to take up any slack. Replace the printer cover and the paper tape.
]
,
(Replace with Victor Ribbon #7010)
GENERAL MAINTENANCE
1.
Do not place the machine in hot, dusty or damp locations.
2.
To clean the housing use a silicon-treated cloth. Do not use water or detergents.
3.
Do not place anything on the housing, particularly on the head of the printer
mechanism:
4.
Turn off the power switch before removing the plug from the AC wall outlet.
5.
Turn the power switch off while not in use.
HOW TO FEED THE PAPER TAPE
1.
Put the new paper roll on the paper arm.
2.
Insert the paper into the slot as indicated.
3.
Depress the paper feed key.
4.
Suitable paper roll:
Width:
max. 57.5mm (2.25")
Diameter:
max. 50mm (1.97")
Paper:
Normal paper
(45kg/1000 sheets/788 x 1091 mm)
-3-
-4-
