Idiomas disponibles
Idiomas disponibles
CAUTION!
Do not measure the voltage when an electric motor lo-
cated within the circuit is being switched on or off. Re-
sulting voltage spikes may damage the meter.
To perform DC voltage measurement:
set the rotary switch at
connect black test lead to COM terminal, and red test lead to
VΩHz%
contact the tips of test probes to the points of measurement; red
probe should be applied to the point of higher potential,
read the measurement result on the display.
5.5 Measurement of resistance
WARNING
Do not perform measurements on the circuit under the
voltage. Before the measurement disconnect the pow-
er and discharge capacitors.
To perform the resistance measurement:
set the rotary switch at Ω
connect black test lead to COM terminal, and red test lead to
VΩHz%
press MODE button, to display Ω on the screen,
contact the tips of test probes to the points of measurement; the
best solution is to disconnect one side of the tested element, to
prevent the remaining part of the circuit interfere with the read-out
of the resistance value,
read the measurement result on the display.
,
mACAP terminal,
mACAP terminal,
CMM-11 – USER MANUAL
CAP,
47
