Stihl FS 460 C-M Manual De Instrucciones página 34

English
The choke knob is in the normal run
position F.
FS 360, 410, 460
5
FS 490
5
If the engine is cold: Depress in the
N
outer edge (arrows) of the choke
knob (5) and then turn it to Start }.
Cranking
Place the unit on the ground: It must
N
rest securely on the engine's guard
plate and the deflector. Check that
32
the cutting attachment is not
touching the ground or any other
obstacles.
Make sure you have a firm footing,
N
either standing, stooping or
kneeling.
Hold the unit firmly on the ground
N
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout.
NOTICE
Do not stand or kneel on the drive tube.
Hold the starter grip with your right
N
hand.
Pull the starter grip steadily.
N
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until the engine
N
runs.
If the engine does not start: Turn the
N
choke knob to the start position }
and repeat starting procedure.
Using the machine
If you have started the machine for the
first time, refer to the notes on "Starting
for first time" in section "Other Hints on
Starting".
If the engine was started in the start
N
position }: Briefly press down the
trigger lockout and the pull the
throttle trigger at the same time –
the choke knob moves to the run
position (F) and the engine settles
down to idling speed.
Your machine is now ready for
operation.
WARNING
The cutting attachment must not rotate
in the Run F position with the engine at
idling speed.
If the cutting attachment rotates when
the engine is idling, refer to notes in
chapter on "Adjusting the Throttle
Cable" or have the machine serviced by
your dealer. STIHL recommends an
authorized STIHL servicing dealer.
Attach the machine to the shoulder
N
strap.
Machine is ready for use.
N
FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L