Idiomas disponibles
Idiomas disponibles
IMPORTANT
SAFETY
INFORMATION
15. When cutting limb or tree trunk that is under
tension, use extreme caution. Be alert for wood
springing back. When wood tension is released,
limb could spring back and strike operator caus-
ing severe injury or death.
16. Carry chain saw from one place to another
• with saw stopped and unplugged
• by holding front handle (never use hand guard
as handle)
• with finger off trigger
• with guide bar and chain to rear
,_t
WARNING:
This product
contains
chemicals
known
to the State of Cali-
fornia to cause cancer or birth defects,
or other reproductive
harm.
_lb WARNING: Some dust created by
power sanding, sawing, grinding,
drill-
ing, and other construction
activities
contains chemicals known (to the state
of California) to cause cancer, birth de-
fects, or other reproductive
harm. Some
examples of these chemicals are:
• lead from lead-based
paints
• crystalline
silica from bricks and ce-
ment and other masonry
products
• arsenic
and chromium
from
chemi-
cally-treated
lumber
Your risk from these exposures
varies,
depending
on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well venti-
lated area, and work with approved safety
equipment,
such as those dust masks
that are specially
designed to filter out
microscopic
particles.
KICKBACK
_IbWARNING:
Kickback mayoccurwhen
the nose or tip of the guide bar touches
an object, or when the wood closes in
and pinches the saw chain in the cut.
Tip contact in some cases may cause a
lightning fast reverse reaction, kicking the
guide bar up and backtowards
the opera-
tor. Pinching the saw chain along the top
of the guide bar may push the guide bar
rapidly back towards the operator. Either
of these reactions
may cause you to lose
control of the saw which could result in
serious injury to user.
Kickback
Safety
Devices
On
This
Saw
This saw has a k)w-kickback chain and reduced
kickback guide bar. Both items reduce the chance of
kickback. Kickback can still occur with this saw.
Followassembly instructionson page 7. Do not remove
front hand guard. Do not replace front hand guard
with substitute.
The following steps will reduce the risk of kickback.
* Use both hands to grip saw while saw is running.
Use firm grip. Thumbs and fingers must wrap
around saw handles.
, Keep all safety items in place on saw. Make sure
they work properly.
, Do not overreach or cut above shoulder height.
, Keep solid footing and balance at all thnes.
, Stand slightly to left side of saw. This keeps your
body from being in direct line with chain.
, Do not let guide bar nose touch anything when
chain is moving (see Figure 1).
, Never try cutting through two logs at same time.
Only cut one log at a time.
, Do not buU guide bar nose or tU plunge cut (boring
into wood using guide bar nose).
* Watch for shifting of wood or other folves that may
pinch chain.
, Use extreme caution when reentering a plevious cut.
, Use low-kickback chain and guide bar supplied
with this chain saw. Only replace these parts with
chains and guide bars listed in this manual.
, Never use dull or loose chain. Keep chain sharp
with proper tension.
',, \
Direction
Do Not Let Guide Bar
\, Touch Here
1
90° Quadrant
Figure 1 - Kickback
Hazard Example: Do Not Let Nose
of Guide Bar Touch Object While Chain is Moving
