Idiomas disponibles
Idiomas disponibles
INSTALLATIONS
PLACEMENT OF THE MOUNTING
indi
PLATE
Removing the microwave oven from the
|.
Remove the installation instructions, Exhaust adaptor,
Wall Studs
filters, glass tray and the small hardware bag. Do not
remove the Styrofoam protecting the front of the oven.
som
Center
2.
Fold back all 4 carton flaps fully against carton sides.
Then carefully roll the oven and carton over onto the
aL
top side. The oven should be resting in the Styrofoam.
Carton
|.
Find the studs, using one of the following methods:
A. Stud finder-a magnetic device which locates nails.
t
t
"
|
B.
Use a hammer to tap lightly across the mounting
location.
2.
After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the stud.
3.
Pull the carton up and off the oven.
Then place a mark halfway between the edges. The
Remove and properly discard plastic bags.
center of any adjacent studs should be 16" or 24" from
screws
Screws
this mark.
men
3.
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
5.
Remove the 2 screws from the mounting plate. This
plate will be used as the rear wall template and for
mounting.
NOTE: You will have to reuse two screws in original loction
of outcase after removing mounting plate.
8505_XAA_03807A-EN+MES.indb
8
2010-07-08
6:52:58
