Kenmore 401.8505 Serie Instrucciones De Instalación página 3

Combinacion microondas compana
Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS
This product
requires a three-prong
grounded
outlet. The
installer must perform a ground continuity check on the power
outlet box before beginning the installation to insure that the
outlet box is properly grounded. If not properly grounded, or
if the outlet box does not meet electrical requirements noted
(under ELECTRICAL REQUIREMENTS), a qualified electrician
should be employed to correct any deficiencies.
CAUTION: For personal
safety, remove house fuse or
open circuit breaker before
beginning installation to
avoid severe or fatal shock
injury.
IMPORTANT-PLEASE
READ
CAREFULLY.
FOR
PERSONAL
SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED
TO AVOID SEVERE OR FATAL SHOCK.
The power cord of this
appliance is equipped with
a three-prong (grounding)
plug which mates with
a standard three-prong
(grounding) wall receptacle
to minimize the possibility of
electric shock hazard from
this appliance.
ground exists
before use
You should have the wall receptacle and circuit checked
by a qualified electrician to make sure the receptacle is
properly grounded.
Where a standard two-prong wall receptacle is encountered,
it is very important to have it replaced with a properly
grounded
three-prong
wall
receptacle,
installed
by
a
qualified electrician.
DO
NOT,
UNDER
ANY
CIRCUMSTANCES,
CUT, DEFORM
OR
REMOVE
ANY
OF THE
PRONGS
FROM
THE
POWER
CORD. DO NOT USE WITH AN EXTENSION CORD.
8505_XAA_03807A-EN+MES.indb
3
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz,
¢
85052, 85053, 85059: 14.5 amps and 1.7 kilowatts.
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to the
requirements of the National Electrical Code or the prevailing
local code for this kilowatt rating. The power supply cord
and plug should be brought to a separate 20 ampere branch
circuit single
grounded
outlet.
The
outlet
box
should
be
located in the cabinet above the microwave oven. The outlet
box and supply circuit should
be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
ELECTRICAL SAFETY
INSTRUCTIONS
CAUTION: For personal safety, the mounting surface must
be capable of supporting the cabinet load, in addition to the
added weight of this 59 pound product, plus additional oven
loads of up to 50 pounds or a total weight of 109 pounds.
CAUTION:
For
personal
safely,
this
product
cannot
be
installed in cabinet arrangements such as an island or a
peninsula. lt must be mounted fo BOTH a fop cabinet AND
a wall.
NOTE:
For easier installation
and
personal
safety,
it is
recommended that two people install this product.
2010-07-08
6:52:50
loading

Este manual también es adecuado para:

401.85052210401.85052310