Idiomas disponibles
Idiomas disponibles
C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
Cl. Adapting microwave blower for outside
back exhaust
1.
Remove and save screw that holds blower Plate to
microwave.
Blower motor screw
2.
Lift up the Blower Plate.
Blower motor
Back of
a
Microwave
Blower motor screw
3.
Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan Blade Openings Facing
Forward
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the blower is
removed and re-installed.
4.
Remove "Parts "A" with tin snips or pliers
Knockouts
5.
Rotate blower unit counterclockwise 180°.
Before Rotation
After Rotation
Back of Microwave
Back of Microwave
8505_XAA_03807A-EN+MES.indb
16
6.
Place the blower unit back into the opening.
AFTER: Fan Blade Openings Facing
Back
End B
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
7.
Secure the blower unit to the microwave with the screw.
Blower-Plate
Back of
Microwave 9 —
From the Mounting Plate
screw
8.
Attach the exhaust adaptor to the rear of the oven by
sliding it into the guides at the top center of the back of the
oven.
Adaptor
Back of
Microwave
From Blower motor screw (after attached the
exhaust adaptor)
Push in securely until it is in the lower locking tabs. Take care
to assure that the damper hinge is installed so that it is at
the top and that the damper swings freely.
C2. Mount the
microwave
oven
see page 12~13 (proceed on Al~A3)
2010-07-08
6:53:06
