Idiomas disponibles
Idiomas disponibles
LUMECTRA LIGHTING
The controller has 4 separate lighted Lumectra Zones that you can customize:
Zone 1
ENTER AND EXIT LUMECTRA PROGRAM MODE
1. To enter Lumectra program mode, hold the LEDS button (
• Zone 1 will flash 3 times to indicate the controller is in Lumectra program mode.
2. Follow the editing steps in the section below to adjust the Lumectra settings. Once complete, hold the LEDS
button on the back of the controller for 2 seconds to save the Lumectra settings.
• All zones will flash 3 times to indicate the settings have been saved and the controller is now out of
Lumectra program mode.
3. Outside of Lumectra program mode, pressing the LEDS button once will turn the Lumectra lighting off or on.
6
Zone 2
Zone 3
) on the back of the controller for 2 seconds.
EDITING LUMECTRA SETTINGS
INDIVIDUAL ZONE ADJUSTMENTS
The button commands below will adjust the Lumectra settings for the selected zone .
+Control Pad Right: Toggle through the 4 zones . The selected zone will flash 3 times .
After Zone 4, the next press will move back to Zone 1 .
+Control Pad Left: Change the lighting mode for the selected zone: "Solid", "Breathing", or "Cycle" .
Zone 4
+Control Pad Up: Increase the brightness for the selected zone .
+Control Pad Down: Decrease the brightness for the selected zone .
A/B/X/Y Buttons: Change the lighting color when in "Solid" or "Breathing" mode for the selected zone .
Each press will toggle through the 6 color options for that button:
: 6 shades of green
Button: Change the speed setting when in "Breathing" or "Cycle" mode .
Three speed options are available: slow, medium, and fast .
Button: When in Lumectra program mode, a single press of the LEDS button
will turn on or off the lighting for that zone .
: 6 shades of red
: 6 shades of blue
: 6 shades of yellow
