Kwikset Powerbolt 269 Guía De Instalación Y Programación página 5

Cerradura electrónica
Idiomas disponibles

Idiomas disponibles

Start the installation
1. Install latch
a
a. Insert the latch and lay the faceplate against the door edge. Use a pencil to mark its
perimeter, then take out the latch.
b. Chisel out the portion you've marked with pencil for about 5/32" (4mm) deep. Score the
area within the borders as clearly and precisely as possible. Ensure the plate can fit flush
with the door edge surface.
c. Insert the latch and tighten it with screws. Be sure the holes for through-bolts (next to
the adjustable cam) are horizontally aligned.
d. It is not necessary to chisel the door edge for the faceplate installation if you use the
drive-in latch. You may install it into the edge bore directly, but be sure the bevel should
face the outside assembly.
2. Install strike
a
a. Half-close the door to lay the latchbolt against the door frame. Mark the position
of faceplate as an indication. Place the strike against the door frame and mark its
perimeter. Make sure the center of strike is perfectly aligned with the center of faceplate.
b. Drill a Ø1" (25.4mm) hole with 1/2" (13mm) depth on the center of strike outline. Then
use the chisel to scrape out the door frame for 1/16" (1.6mm) deep within the traced
outline. Make sure to chisel deep enough to allow the strike to lay flush with the frame
surface.
c. Insert the strike and tighten it with screws.
Note: please use "tapping screws" for a metal door.
b
b
c
d
d
4
loading